• Address: Lubbock, TX 79408 (map)
• Date Posted: 10/07/09

MIG welding power source. Top of the line from Miller. 450 amps at 100% duty cycle. Nearly 600 amps at 60% duty cycle. Sweetest mig welder you will ever use. Strictly 3 phase for smooth arc.


Line voltage compensation keeps welding parameters constant even when input voltages change ±10%. Eliminates need to change welding parameters throughout the day.

Two positive output terminals allow operators to optimize arc performance.

Unique Fan-On-Demand™ cooling system operates only when needed. Reduces contaminants drawn into the machine and excess noise in work areas.

Enclosed circuit board provides additional protection by eliminating contaminants which cause premature failure of components.

Thermal overload protection nternal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted.

Remote control capability allows operators fine tuning capability at an extended distance.

15 amp 115 VAC duplex receptacle allows operators the flexibility to run grinders, drills, coolers, etc. from power source without the need for additional 115 VAC power in weld area.

Power efficient for exceptional value and return on your investment.

Digital meters for presetting or monitoring welding voltage or amperage for more precise control.

$3800 list price. Get it here at an over 50% discount!

This is a new machine with some storage and handling marks. Was never attached to power until I hooked it up to test it. Works perfect!

No cables or cords included.

Arguably the finest CV mig welding power source ever built. 450 amps, 100% duty cycle. 230/460/575 volts, 3 phase only.

See the info on Miller's website here-- http://www.millerwelds.com/products/mig/deltaweld_452/

I also have some Deltaweld 652's in excellent, nearly new condition and a couple of the Deltaweld 451 units with Miller 22a feeders in good condition.

David
806-543-0980

Print Ad